Posted by Amelia Whitehart on December 29, 2019 in Home
Hire Jacksonville, FL painters and house paint tricks: When painting the trim, you don’t have to be neat. Just concentrate on getting a smooth finish on the wood. Don’t worry if the trim paint gets onto the walls. You’ll cover it later when painting the walls. Once the trim is completely painted and dry (at least 24 hours), tape it off (using an “easy release” painter’s tape), then paint the ceiling, then the walls.
Grab a roll of painter’s tape—the cousins recommend FrogTape—and firmly apply it to the edges of the room’s corners, base and crown moldings, and door and window casings, using a putty knife to seal if needed. “Getting a good seal so paint doesn’t get under the tape is everything, plus it will pull away clean after everything is dry,” they say. If you dare (or have an artist’s steady hand), you can skip taping entirely. Remove outlet and light switch covers and apply painters tape to protect outlets and switches from paint drips. Use a wooden paint stick to stir the paint, and re-stir often throughout the project. If you’re using more than one gallon of paint, combine the cans in a large bucket in case there is a slight variation in color.
Filling gaps with a paintable acrylic-latex caulk cuts down on drafts and makes your trim look better than new. The secret to using caulk is to cut the tip smaller than you think it should be; too much caulk makes a mess. Also, instead of using a nail to break the inner seal, use a small wire so you don’t stretch out the nozzle. Also consider buying a dripless caulk gun, which will automatically back off the pressure after each pull on the trigger to prevent unwanted oozing. The pros were split on this tip. “Masking tape is problematic,” says Mark Dixon, a painter in Missoula, Montana, and author of “House Painting Inside and Out” (Taunton Press, 1997). “Paint can bleed behind the tape, or remove the paint it’s stuck to.” Another problem is bridging. “Latex paints form a skin,” says Dixon. “Removing painted tape can tear the skin, resulting in a ragged rather than a sharp line.” Lastly, taping takes time. “Learning how to cut in with a brush takes practice, but if you can do it, you’ll leave most tapers in the dust,” Dixon says. (Cutting in is painting just the surface you want, not the surface adjacent to it — for example, where a wall meets the ceiling.) On the other hand, “If you can’t cut in, you can’t beat tape,” says Span. The pros we spoke with all recommend painter’s (blue) tape because it’s easier to remove than masking tape. To prevent bleeding, Span uses a putty knife to bed the tape. After letting the paint dry, he scores the edge of the tape line with a utility knife to avoid tearing the paint. Find extra details at Hire jacksonville painters.
The “same” color of paint can vary between cans. “That difference can be glaringly obvious if you pop open a new gallon halfway through a wall,” a retired painter tells PM. To ensure color consistency from start to finish, pros mix their cans of paint in a five-gallon bucket (a process called “boxing”). Some pros then paint directly out of the bucket. This eliminates the need to pour paint into a roller tray, though the heavy bucket is harder to move. That’s because, unless you’re uncommonly motivated, you’re not going to have freshly shaken paint for the duration of your project. And you can’t bring settled paint back to life with a stir stick alone. No, you need to pour the paint back and forth between two buckets until you’ve scraped and mixed the solids at the bottom. That’s the best, and really only, way to ensure your paint is mixed. And if you have paint in several different cans, you want to mix those, too, to make sure everything is uniform. (See “boxing.”)
Below you will find the absolute best painters in Jacksonville, FL. These award winning painters & painting companies have set themselves apart in the home painting and even the commercial painting industry. Home painting you can count on! Find additional details at https://www.painters-jacksonville.com/.