Posted by Marian Vasilescu on October 24, 2019 in Shopping
Spot welding is often selected for joining sheet metal fabrications, stampings and assemblies because it is fast, reliable and economical. However, numerous design considerations can affect the quality and cost of the weld, among them: size of the spot weld, accessibility, positioning, materials and thicknesses being joined, and the number of spots needed to attain the desired strength. This section will focus primarily on resistance spot welding (RSW) and resistance projection welding (RPW) since these processes are most commonly used due to their speed and flexibility. See Figure 1, for schematics of RSW and RPW.
If the sheets are the same thickness then the power setting used for plug welding would be the same as you would use for 1.5 times the thickness of one of the sheets. This is the sort of penetration you would expect from a plug weld. The molten pool is just breaking out of the reverse of the back sheet. The heat marks indicate the weld has arced against the back sheet rather than at the side of the hole. If you don’t get these marks then consider a little seam welding just to be sure. There is a special clamp designed for plug welding that makes life really easy. The parts you see in the photograph are attached to a normal mole grip. This clamp came in a set of three random welding clamps all of which are extremely useful.
How Does Spot Welding Work? A form of resistance welding, spot welding is one of the oldest welding processes whereby two or more sheets of metal are welded together without the use of any filler material. The process involves applying pressure and heat to the weld area using shaped alloy copper electrodes which convey an electrical current through the weld pieces. The material melts, fusing the parts together at which point the current is turned off, pressure from the electrodes is maintained and the molten “nugget” solidifies to form the joint. See more info on Tecna Spot Welder Arms.
In the same category you also find generators, always operating on direct current, intended for car bodywork including repairing dented panels. The machine consists of a holder which lets you position your welding gear precisely in front of the deformed zone, and uses mechanical or hydraulic force to restore it to its original shape. All you have to do is crack out your hammer to fine-tune the finish. The “gougeonneuse”, as it’s known in France, can be used to mend tow rings and other specific parts. The huge advantage of being able to return a panel or component to its original shape without needing to disassemble the car body makes this machine a must-have tool for bodywork!